Hayward

| FDXLBKP1930

Bezel and Keypad Assembly Kit for H-Series Pool Heaters

Reg. $79.99 Save 38%
Currently out of stock

Free Deliveries

100% satisfaction guaranteed. More Details

Every Purchase Has a Purpose

5% goes to a cause you care about. Learn More

Anchor to Specifications and Description

Description

Your pool is your pride and joy, as it should be. But, sometimes your pride and joy is difficult to read, which is why you need this Bezel and Keypad Assembly Kit for H-Series Pool Heaters. Making managing the temperature of your pool a breeze, this bezel kit is easy to install. And, since it's an accessory to the Hayward H-Series line, it will work to reduce those utility costs. This piece alone will not heat your pool. This part is actually an accessory, made to replace damaged control panels or as an upgrade for your heater. If you're in need of a heater, refer to the wide variety we have here on Spreetail.com. Often times our pool's control panels can get damaged because they are in direct sunlight for most of the day, and are exposed to water without much resistance. By the time we realize they've been compromised, it's too late. If you have noticed that your pool control panel has stopped working, we suggest trying to manually reset the unit before replacing it with this bezel kit. If that doesn't work, then you'll be in need of a replacement. Like we mentioned before, this bezel and keypad are meant for Hayward H-Series pools. If you're unsure, our specialists will be able to clarify, and we're available all hours of the day. Once you have your new bezel and keypad assembly kit, installation is simple. We advise that you power down the heater, then remove your old display from the heater using a screwdriver. Disconnect the old unit from the PC board by disconnecting the ribbon cable. After that, remove the PC board's screws and attach it to your new keypad kit. Re-insert and tighten all of the aforementioned screws. Once it's attached, turn on your heater and it should be back to normal. You'll appreciate the benefits of both this kit and an H-Series heater. This assembly kit is resistant to corrosion, and you'll be able to completely manage your water flow all from the panel. The heaters themselves will help save you up to 18% thanks to the reduced pump run time, and the low NOx emissions meet clean air quality standards.

Highlights

  • Standard cupro nickel heat exchanger
  • Up to 18 percent savings through reduced pump run time
  • Helps resist salt water and chemical corrosion
  • Consistent water velocity through all tubes creates faster heating
  • Low NOx emissions meets clean air quality standards
  • 2 x 2.5 inch CPVC union plumbing connections
  • Water flow is totally managed
  • Dimensions: 0 x 3 x 0 inches
  • Weight: 0.7 pounds
  • Part number: FDXLBKP1930
  • Manufacturer warranty: 1-year warranty

24/7 Access to Experts

Free 1-3 Day Delivery

We make it easy to get what you need, ASAP.